Category Archives : D7 RSS feed for this section

Adding a LCD to Nanodlp

Description If you are going to be using a RaspberryPi with Nanodlp installed then this mod may be handy. You can add a 16×2 LCD (I2C protocol) to the pi and then configure Nanodlp to use the LCD...

Printable Mods

Description This is a collection of printable user mods that can be made to the D7 printer. Wanhao is pretty good about implementing enhancements over time so check your printer to see if it could ben...

Recommended Tools

Tools Here are some links to handy tools for use with the D7 resin printer.

Fixing Power Button on v1.3

Description The v1.3 D7 printers (the ones with the vents in the back) had the power switch changed and are really long, so long they backside of the switch assembly hits the UV cooling fan. This butt...

Adding a See-thru Enclosure / Cover

Cover Options The original D7 showed a see through cover but ended up shipping with a steel cover. Although my prints are usually small and take a long time before they get above the vat where they ar...

Adjusting Pre-load on bed bracket if it is loose

Description If the D7 bed has some slop in it (can be wiggled easily or if you see it flex a lot during the peeling process) then you may need to adjust the preload on the bearings that hold the bed b...

Installing UV Cooling Fan Shroud

Description The 30 Watt UV LED gets pretty warm and needs to be cooled so it will not burn out. The current models of the D7 appear to run warm after time and it is thought that the issue could be rel...

Re-installing Z Anti-backlash Nut

Description If you take the build platform all the way off and the z nut is removed from the threaded rod it will need to be installed correctly because of the anti-backlash nut. Here is a quick video...

Adding Customized Button to Nanodlp

Adding CustomĀ Button Actions You can add your own buttons on Nanodlp to do various functions and have these accessible on certain screens all the time or only when the printer is Idle (recommended). ...

D7 Unboxing Checklist

Description The D7 is a good printer but has been seeing some damage from shipping and a few QC mistakes. This list will cover some known issues that should be checked before printing. A few of these ...

Skip to toolbar