Category Archives : Duplicator I3 RSS feed for this section

Pause At Layer Height

There are multiple ways to pause a print and change filament on the Duplicator i3.  In this article I’ll discuss several procedures. Note, this guide is aimed at the Duplicator i3 only.  Some of t...

Spare Parts

Spare Parts Here are some links to some spare parts for the I3 series printer  printer. Fans: 40mm Quiet Extruder cooling fan from Amazon 50x15mm Blower fan for the Diii/CiiiCooler Mod from Amazon Y ...

Mods / STL Files

Mods for the I3 Plus / Maker Select 3P Z Brace Mod by Morgajel: https://www.thingiverse.com/thing:2349318 Heated Bed Isolators (for bed shorting issue) by Joemadd3n: Inline with the September 2016 W...

D7 NanoDLP (and standard) Firmware

About the changes to the D7 Firmware The Wanhao D7 uses the Creation Workshop software to slice and control the printing process. The company that makes the software has changed hands and charges for...

Hotbed Burning Terminal Fix with MOSFET Board

Description The terminals where the hot bed wires screw / plug into the main board are known to burn or stop working. This is caused by the amount of power that passes through the terminal connectors ...

Adding Heating LED Indication to Heatbed

Description Some hotbeds come with LEDs that light when the bed is powered and heating. If your bed does not come with these there is a chance you could add them yourself. Check the bed where the powe...

Heat Bed Terminal Burning Fix

Description The terminals where the hot bed wires screw / plug into the main board are known to burn or stop working. This is caused by the amount of power that passes through the terminal connectors ...

Printer specs for slicers

Here are the main specs that can be used for setting up slicer / Cura profiles (we also have some already defined here. Machine Settings: e-steps/mm (see this page on how to configure e-steps): This v...

Melzie to Ramps Conversion

This is a copy of the instructions from http://beginner3dprinting.com which has been offline. There are no photos and I haven’t been in touch with the author yet since the website is offline but...

Board Replacement Options (RAMPS, RADDS, Clone Mini)

So your Melzi board have blown, maybe due to a user error or faulty electronics or maybe you just want to use a better main board. There are quite a few options available: RADDS 32bit Processor, remov...