About the changes to the D7 Firmware My favorite alternative to a dedicated computer for slicing is to use a RaspberryPi3 and a program called nanoDLP. Please note that nanoDLP prefers that the mot...
Category Archives : Basic Mods RSS feed for this section
Flexible Filament Mod
This modification applies to all versions of the Duplicator i3. Performing this mod may void your warranty. Proceed at your own risk. Description This mod keeps the flexible filaments from escapin...
Adjustable Z Endstops
This modification mostly applies to early V1 of the Duplicator i3. Later V1s as well as V2s have a second set of mounting holes to mount the Z stop switch higher to accommodate a 1/8″ or 3...
Extruder Gear
This modification applies to all versions of the Duplicator i3. Description The original extruder gear is made from brass and has large dull teeth spaced far apart. Jetguy did some test prints an...
Adding a Glass Bed
This modification applies to all versions of the Duplicator i3. Description On other printers, the problem in the past was the heater for the HBP was fiberglass circuit board and then an aluminum...
Bed screw and thumbwheel mod
This modification applies to all versions of the Duplicator i3. Description This modification is probably the first one you’ll want to make. It helps make leveling the bed much easier as we...