Easy Install Method You will need a RaspberryPi3 to run Nanodlp on and a 8gb or greater SD card. The following kit contains a Pi3, proper power supply and enclosure or the pi3 board only. You can pick...
Category Archives : D7 RSS feed for this section
Changes to the V1.4 (Beta version)
As we know, Wanhao is really fast at implementing changes to their products based on user feedback. The following images will show what has changed in the v1.4 printer that started shipping May 22th, ...
Bed Alignment Fix for v1
Description On the v1 D7 printers the bed assembly doesn’t line up with the LCD correctly using the stop on the z bracket so this part can be added to keep the plate from being installed too fa...
Upgrade Fan Kit for v1 and v1.2 Users
Dear D7 V1.0 and V1.2 users, From 26th April 2017, all the D7 printers are in Version 1.3 with side 60*60mm cooling fan. Anyway for any V1.0 and V1.2 user, we would provide V1.3 upgrading Pack and Upg...
Adding a LCD to Nanodlp
Description If you are going to be using a RaspberryPi with Nanodlp installed then this mod may be handy. You can add a 16×2 LCD (I2C protocol) to the pi and then configure Nanodlp to use the LCD...
Printable Mods (replacement parts, new parts, etc)
Description This is a collection of printable user mods that can be made to the D7 printer. Wanhao is pretty good about implementing enhancements over time so check your printer to see if it could ben...
Recommended Tools & Supplies
Supplies and Tools Here are some links to handy tools for use with the D7 resin printer. “We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designe...
Fixing Power Button on v1.3
Description The v1.3 D7 printers (the ones with the vents in the back) had the power switch changed and are really long, so long they backside of the switch assembly hits the UV cooling fan. This butt...
Adding a See-thru Enclosure / Cover
Cover Options The original D7 showed a see through cover but ended up shipping with a steel cover. Although my prints are usually small and take a long time before they get above the vat where they ar...
Adjusting Pre-load on bed bracket if it is loose
Description If the D7 bed has some slop in it (can be wiggled easily or if you see it flex a lot during the peeling process) then you may need to adjust the preload on the bearings that hold the bed b...